The handle of each front door has a
sensor. That sensor works with the
remote so you can automatically
unlock/lock the door(s).
If you do not open any of the doors
within 30 seconds, they will
automatically relock.
The unlock sensors do not operate
when:
Theremoteisnotwithinthe
operating range.
To change the ‘‘DOOR UNLOCK
MODE’’ setting, see page .
If a remote is within operating range
while you wash your vehicle or when
it is raining heavily, the door sensors
may respond by unlocking the doors.
When you unlock the door(s), some
exterior lights blink twice and the
system beeps twice.
To change the ‘‘KEYLESS ACCESS
LIGHT FLASH’’ setting, see page
.
To change the ‘‘KEYLESS ACCESS
BEEP’’ setting, see page .
The remote is too close to the
vehicle.
By default, only the driver’s door
unlocks when you grab its handle.
All the doors unlock when you grab
the handle of the front passenger’s
door.
When the doors are unlocked.
The vehicle battery is dead.
Theremotebatteryisdead.
If you wear a glove while grabbing a
front door handle, the door sensor
maybeslowtorespondormaynot
respond by unlocking the doors.
108
110
106
Unlocking the Door(s)
Keyless Access System
Instruments and Controls
161