194 | | 195
MAINTENANCEMAINTENANCE
TABLE OF
CONTENTS
NAVIGATION
VISUAL INDEX DRIVING
SAFETY
INFORMATION
HANDLING THE
UNEXPECTED
INSTRUMENT
PANEL
MAINTENANCE
VEHICLE
CONTROLS
SPECIFICATIONS
AUDIO AND
CONNECTIVITY
CLIENT
INFORMATION
BLUETOOTH®
HANDSFREELINK®
VOICE
COMMAND
INDEX
ACURALINK® INDEX
Changing Wiper Blades
If the wiper blades leave streaks across the windshield, try cleaning them first with a paper towel
or soft cloth and wiper fluid. If the wiper blade rubber has deteriorated, you should change the
wiper blades.
1. Hold the wiper switch in MIST as you change the power
mode to VEHICLE OFF (LOCK). The wiper arms will move into
the service position.
2. Lift both wiper arms.
3. For each wiper, press and hold the tab, then slide the wiper
blade holder out from the wiper arm.
4. Push to compress the wiper blade until it clears the end cap,
then pull to slide it up and out of the holder.
5. Slide the new wiper blade into the holder and secure the end
into the cap. Slide the blade holder onto the wiper arm until
it clicks, then lower the arm.
6. Set the power mode to ON. Hold the wiper switch in MIST
until the wiper arms return to their normal position..
Wiper
Blade
the bottom
End Cap at
Avoid dropping the wiper arm, as it may damage the windshield.
NOTICE
To Next Page
Loading...
Need help?
General
