38 | | 39
SAFETYSAFETY
TABLE OF
CONTENTS
NAVIGATION
VISUAL INDEX DRIVING
SAFETY
INFORMATION
HANDLING THE
UNEXPECTED
INSTRUMENT
PANEL
MAINTENANCE
VEHICLE
CONTROLS
SPECIFICATIONS
AUDIO AND
CONNECTIVITY
CLIENT
INFORMATION
BLUETOOTH®
HANDSFREELINK®
VOICE
COMMAND
INDEX
ACURALINK® INDEX
n Installing a Child Seat
1. Move the passenger seat to the rearmost position.
2. Place the child seat on the passenger seat.
3. Route the seat belt through the child seat according to
the seat manufacturer’s instructions, and insert the latch
plate into the buckle. Insert the latch plate fully until it
clicks.
4. Slowly pull the shoulder part of the belt all the way out
until it stops. This activates the lockable retractor.
5. Let the seat belt completely wind up into the retractor,
then try to pull it out to make sure the retractor is locked.
If you are able to pull the shoulder belt out, the lockable
retractor is not activated. Pull the seat belt all the way
out, and repeat steps 3–5.
6. Grab the shoulder part of the seat belt near the buckle,
and pull up to remove any slack from the lap part of the
belt. When doing this, place your weight on the child seat
and push it into the vehicle seat.
7. Make sure the child seat is firmly secured by rocking it
forward and back and side to side; little movement should
be felt.
To deactivate a lockable retractor, release the buckle and allow the seat belt to wind up all
the way.
To Next Page
Loading...
Need help?
General
