−
− The fluid level should be between
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected for leaks or
worn brake pads.
Check the fluid level in the brake
fluid reservoir monthly.
The brake fluid should be replaced
according to the time recommenda-
tion in the maintenance schedule.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
container, as a temporary
replacement. However, the use of
any non-Honda brake fluid can cause
corrosion and decrease the life of the
system. Have the brake system
flushed and refilled with Honda
Heavy Duty Brake Fluid DOT 3 as
soon as possible.
Brake fluid marked DOT 5 is not
compatible with your vehicle’s
braking system and can cause
extensive damage.
If it is not, slowly add proper fluid
until it starts to run out of the hole.
Reinstall the filler plug and tighten it
securely.
The transfer assembly fluid should
be drained and refilled with new fluid
accordingtothetimeanddistance
recommendations in the
maintenance schedule.
Viscosity
UseaSAE90orSAE80W-90
viscosity hypoid gear oil, API service
classified GL4 or GL5 only, in the
transfer assembly.
Tightening torque:
Brake SystemBrake Fluid
Maintenance
Transfer Assembly Fluid, Brake Fluid
319
MAX
MIN
SAE 90: above 0°F ( 18°C)
SAE 80W-90: below 0°F ( 18°C)
33 lbf·ft (45 N·m , 4.6 kgf·m)
０２／０７／３０ ２２：１３：２８ ３１Ｓ３Ｖ６２０ ０３２４
To Next Page
Loading...
Need help?
General
