AcuRite 02099 - Programmable Alarms; Setup an Alarm; Disable an Alarm

10
To manually clear a HIGH or LOW record, press and HOLD both the “
“ and
“ “ buttons simultaneously for 3 seconds while viewing the record(s) you wish
to clear. Dashes display to conrm you have cleared the record(s).
Programmable Alarms
This display features programmable alarms that sound an alert to notify you
when a value (for temperature or humidity) has been reached or exceeded.
When an alarm is triggered, the display emits an audible beep and ashes data
in the affected category. You can customize the alarms by turning ON or OFF
the alarms you’d like activated or deactivated, and by inputting your own values
to trigger the alarm.
Setup an Alarm
1. Press and release the “ ” button until the reading for which you wish to
set an alarm is shown on the display. “ ” will be shown.
2. Press and release the “ “ or “ “ buttons until “ ” appears.
3. Press and release the “ ” button. The current HIGH alarm value will be shown.
3. Press and release the “ “ or “ “ buttons to adjust the alarm’s HIGH value.
4. Press and release the “ ” button. The current LOW alarm value will be shown.
5. Press and release the “ “ or “ “ buttons to adjust the alarm’s LOW value.
6. Press and release the “ ” button to end alarm adjustments, OR press
and release the “ ” button to cycle to the next reading.
Disable an Alarm
1. Press and release the “ ” button until the reading for which you wish to
disable an alarm is shown on the display. “ ” will be shown.
2. Press and release the “ “ or “ “ buttons until “ ” appears.
3. Press and release the “ ” button to cycle to the next reading.
4. Repeat steps 1-3, as needed.
NOTE: To disable ALL alarms at once, press and HOLD the “ ” button for
10 seconds.
You will automatically exit alarm SET MODE if no buttons are pressed for
10 seconds. Enter alarm SET MODE at any time by pressing the “ ” button.