Remote Control Programming Manual
30 Graphics: Example 11 — Creating a movie marquee
8 Press RUN.
9
Then press Y to save
graphic
A
.
10
Press SELECT until a
question mark appears.
11
Type
B
as the name of the
next graphics file.
12
Repeat the previous steps
to draw graphics
B
and
C.
(Both are just smaller
versions of graphic
A.
)
Use the COLOR key to
make all the dots in graphic
B green, and all the dots in
graphic C amber.
NOTE:
In order to display a DOTS graphic, it must be placed in a text message.
In the following steps, we’ll create a text message and add the three DOTS graphics just created.
13
Press BACK to return to
PROG TEXT
.
14
Press SELECT until a
question mark appears.
15 Press A.
16
Hold down SHIFT and
press 4 for FLASH.
17
Hold down SHIFT and
press 8 for SPEED.
18
Press SELECT until
[SP5]
appears. (This is the fastest
speed.)
19
Insert the first DOTS
graphic you created (file A)
by holding down SHIFT
and pressing 0.
PROG DOTS A
PROG DOTS ?
PROG DOTS B
DOTS graphic
B
DOTS graphic
C
PROG TEXT A
PROG TEXT ?
A]
A] [FLS]
A] [FLS][SP4]
A] [FLS][SP5]
The letter
A
is the name of the graphic file.
A] FLS][SP5][DOT]A
To Next Page
Loading...