Remote Control Programming Manual
2 General information: Using a Remote Control to operate your sign
To program a sign with a Remote Control:
• stand at least 5 feet and no more than 30 feet from the sign
• make sure nothing reflective is in front of the sign (Light from the
sign’s display that is reflected back can interfere with the Remote
Control.)
• if nearby fluorescent lights interfere with the Remote Control,
you may have to relocate either the lights or the sign.
If a sign is this far from the floor...
...then hold a Remote Control this far
away:
10 feet from 10 to 30 feet
15 feet from 19 to 30 feet
20 feet from 25 to 30 feet
Figure 2: Using a Remote Control with a sign
To Next Page
Loading...