ADC e-shpyg 3 - Taking Measurements; Device Power and Cuff Connection; Setting Measurement Parameters

Taking Measurements
Turn on the power
Turn on the device by moving the
On/Off Switch to the ON position.
Connect the cuff
Connect the cuff to the extension
tubing.
Set maximum inflation pressure
Select desired maximum inflation pressure or choose "AUTO".
Refer to page 23 for the section on “Set maximum inflation pressure“
Select an operation mode
There are three measurement modes.
Slide the switch to select 1x (standard single measurement),
Manual, or 3x Mode (automatic three-reading average).
18
13
T
TM
23 - 40 cm
Reusable BP Cuff
11
Adult