Seite 9
InTroduCTIon
This part of the manual deals mainly with fitting the add-e NEXT retrofit kit on
your Brompton folding bike. For models P und T Line (build from 2022) a standard
installation such as with models build until 2021 ist not possible. These models are
further elaborated upon here. A detailed description of the individual components,
along with instructions for use, technical specifications, and functionality, can be
found in the user manual.
The installation of the add-e NEXT retrofit kit for the Brompton folding bike does
not require any special tools.
Before installation, the assembly and user manuals should be read carefully. The
respective steps must be followed precisely in the given order. Only original parts
from GP Motion GmbH or accessories recommended by them may be used.
1. Turn the Brompton folding bike upsi-
de down and fold in the rear wheel.
Remove the pump, if present.
This applies to all Brompton models.
Turn the Brompton folding bike upside down
Preparation
The InsTallaTIon
For optimal use of the add-e NEXT retrofit drive, it must be ensured that only the
original tyres or the original tyre dimensions—35-349 (ETRTO measurement)—are
used.
2a.For A & C Line models, replace the
original stopper with the supplied
cap nut.
When attaching the cap nut, reuse
the original washers.
This step is not necessary for T & P
Line models.
Replace the original stopper
To Next Page
Loading...