add-e NEXT - Attaching the Battery Holder with Steel Straps S

Seite 10
3. For all models:
Remove or shorten the original mud-
guard. When shortening, it is recom-
mended to use sturdy scissors. Defla-
ting the tyre will make this easier.
Remove or shorten the original mudguard
Attaching the battery holder with steel straps
The Brompton folding bike does not have pre-drilled mounting points for a bottle
holder. Therefore, the installation of the battery holder is done using the supplied
steel straps.
TIP!
As an addional help for aaching the baery holder with steel
straps, the add-e NEXT installaon video is available at
www.add-e.at/montage.
PLEASE NOTE!
The steel straps are suitable for single installaon only. If they are
cut incorrectly, for example, if they are cut too short, or if the holder
needs to be reinstalled, new steel straps must be used.
PLEASE NOTE!
When shortening, it is recommended to use sturdy scissors. Dea-
ng the tyre makes this step easier.
2b.For P & T Line models, remove the
reflector instead of the cap nut.
This step is not necessary for A & C
Line models.
For P & T Line models remove the reflector