Bring your own components:
Raspberry Pi x1
18650 battery (high current power battery) x2
9.2 Precautions for assembly
Due to the large number of servo used in this product, the installation of the servo
has a greater impact on the performance of the product, so you need to power on the
servo and control the servo to rotate to the middle position before installing the servo
rocker arm, in this way, the rocker arm of the servo installed at the specified angle can
be in the middle position of it.
Steps to power on the servo:
1.Boot the Raspberry Pi.
2.Install the servo. Pay attention to the direction of the interface during
installation. The yellow wire is connected to the yellow pin, the red wire is connected
to the red pin, and the brown wire is connected to the black pin.
To Next Page
Loading...
