ADJ FOCUS BEAM LED - Page 23

23
SYSTEM MENU
Primary-Secondary Conguration:
This function will allows you to link units together to run in a Primary-Secondary set-up. In a
Primary-Secondary set up one unit will act as the controlling unit and the others will react to the controlling
units built-in programs. Any unit can act as a Primary or as a Secondary however, only one unit can be
programmed to act as the “Primary.”
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data cables
to link your units together. Remember that the Male XLR connector is the input and the Female XLR
connector is the output. The rst unit in the chain (primary) will use the female XLR connector only. The
last unit in the chain will use the male XLR connector only.
2. Set the “Primary” unit to your desired mode of operation.
3. Connect the rst “Secondary” unit to the “Primary.”
4. Set the “Secondary” unit(s) to DMX control.