ADJ Mega Bar RGBA - Page 12

ADJ Products, LLC - www.adj.com - Mega Bar RGBA User Manual Page 12
Mega Bar RGBA ADJ RFC Operation
The ADJ RFC remote (sold seperately) has many different functions and al- lows you
to control your Mega Bar RGBA from long distance. The ADJ RFC remote can control
your system up to 150 ft. To use the RFC you must first activate the fixtures receiver,
to activate the receiver please see the instruc- tions on pages 10-11.
BLACKOUT Pressing this button will blackout the fixture.
AUTO RUN This button will run an automatic program. You can control the fade speed
of the Auto Run by pressing the Flash button twice and then ad- just the speed using
the “+” and “” buttons. Press the Flash button once to enter Flash mode and use the “+”
and “” buttons to adjust the Flash speed.
PROGRAM SELECTION This button will activate 1 of 2 modes; Color Select mode
or Built-In Programs.
1. Press this button so that the Red LED’s flash, you are now in Color Static mode. Use
the “+” or “” to scroll through the 15 colors. Once you have found your color, you can
press the Flash Button to activate strobing and use the “+” or “” to adjust the Flash
rate.
2. Press this button so that the Green LED’s flash, you are now in Built-In Program
mode. Use the “+” or “” to scroll through the 22 built-in programs. Once you have
found your desired program and you can press the SPEED button and then use the
“+” and “” buttons to adjust the program speed. You can press the Flash Button to
activate strobing and use the “+” or “” to adjust the Flash rate. Press the Flash button
twice to enter the Fade speed adjustment and use the “+” and “” buttons to adjust the
Fade speed.
FLASH This button will activate the flash (strobe) effect. You can control the flash
speed by pressing the “+” and “” buttons.
SPEED Press this button and use the “+” & “” buttons to adjust the speed of the Built in
Programs.
SOUND ACTIVE - This button activates sound active mode. Use the “+” & “” buttons to
adjust the sound sensitivity level.
R G B W/A - Press either one of these buttons and the press the “+” or “” to adjust the
brightness.
“+” and “” - Use these buttons to adjust the flash rate, speed of the Auto Run and built
in programs, sound sensitivity, and output intensity. Use these buttons to scroll
through the static colors and built in programs.