ADJ Products, LLC - www.adj.com - Mega Bar RGBA User Manual Page 11
Mega Bar RGBA Primary - Secondary Configuration
Primary-Secondary Configurations:
This function will allows you to link units together to run in a Primary- Secondary mode.
In Primary-Secondary operation one unit will act as the controlling unit and the others
will react to the controlling units built-in programs. Any unit can act as a Primary or as a
Secondary however, only one unit can be pro-grammed to act as the “Primary.”
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard
XLR data cables to link your units together. Remember that the Male XLR connector
is the input and the Female XLR con- nector is the ouput. The first unit in the chain
(Primary) will use the female XLR connector only. The last unit in the chain will use
the male XLR connector only.
2. Set the “Primary” unit to your desired operating mode and then connect the
“Secondary” unit or units.
3. For the “Secondary” unit(s) press the MODE button until “SLAu” is displayed. The
“Secondary” unit(s) will now follow the “Primary” unit.
To Next Page
Loading...
