ADJ Products, LLC - www.adj.com - Mega Bar RGBA User Manual Page 10
Mega Bar RGBA Operating Instructions
3. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The
Channel modes are listed below:
To run the 4 Channel Mode, press the MODE button until “Ch.01” is displayed.
To run the 6 Channel Mode, press the MODE button until “Ch.02” is displayed.
To run the 7 Channel Mode, press the MODE button until “Ch.03” is displayed.
To run the 9 Channel Mode, press the MODE button until “Ch.04” is displayed.
To run the 10 Channel Mode, press the MODE button until “Ch.05” is displayed.
To run the 18 Channel Mode, press the MODE button until “Ch.06” is displayed.
To run the 34 Channel Mode, press the MODE button until “Ch.07” is displayed.
4. Please see pages 13-22 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in the fixture via the
XLR connections to any standard DMX controller.
Default Running Mode:
This is a default running mode. When this mode is activated all modes will return to their
default settings and a Auto program will run.
1. Plug the fixture in and press the MODE and SET UP buttons at the same time.
ADJ RFC:
This function is used to activate and deactivate the ADJ RFC (Remote Control). When
this function is activated you can control the fixture using the ADJ RFC. Please see the
next page for ADJ RFC controls and functions.
1. Plug the fixture in and press the MODE button until “Auto” is displayed.
2. Press the SET UP button until “rF.XX” is displayed. “XX” represents either “on” or “off”.
3. Press the UP or DOWN buttons to either activate the remote function (On) or
deactivate it (Off).
To Next Page
Loading...
