ADJ Products, LLC - www.adj.com - Mega Bar RGBA User Manual Page 9
Mega Bar RGBA Operating Instructions
Sound Active Mode:
In this mode the Mega Bar RGBA will react to sound, and chase through the different
colors.
1. Plug the fixture in and press the MODE button until “SU.XX” is displayed. “XX”
represents the sound sensitivity level.
2. Use the UP or DOWN buttons to adjust the sound sensitivity. “SU.00” is off, “SU.01
is the lowest sensitivity, and “SU.31” is the highest. After adjusting the sound
sensitivity, press SET UP if you wish to activate the Flash mode.
3. “FS.XX” will now be displayed, this is Flash mode. The Flash can be adjusted
between “FS.00” (flash off) to “FS.99” (fastest flash).
Auto Run Mode:
In this mode the Mega Bar RGBA will run a auto program.
1. Plug the fixture in and press the MODE button until “AUTO” is dis- played.
2. After you have activated Auto Run mode, press the SET UP but- ton to adjust the fade
time.
3. Once you press SET UP “Fd.XX” should be displayed. Use the UP or DOWN buttons
to set the fade speed to either “Fd.00” (fade off) or between “Fd.01” (fastest speed)
and “Fd.99” (slowest speed). After adjusting the fade speed, press SET UP if you
wish to activate the Flash mode.
4. “FS.XX” will now be displayed, this is Flash mode. The Flash can be adjusted
between “FS.00” (flash off) to “FS.99” (fastest flash).
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own
programs tailored to their own individual needs. This function also allows you to use your
fixtures as spot lights. The Mega Bar RGBA has 7 DMX modes: 4 Channel mode, 6
Channel mode, 7 Channel mode, 9 Channel mode, 10 Channel mode, 18 Channel
mode, and a 34 Channel mode. See pages 13-22 for each modes’ DMX traits.
1. This function will allow you to control each individual fixture’s traits with a
standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until “d.XXX” is
displayed. “XXX” represents the current displayed ad- dress. Use the UP or
DOWN buttons to select your desired DMX address, then press the SETUP
button to select your DMX Channel mode.
To Next Page
Loading...
