ADJ Products, LLC - www.adj.com - Mega Bar RGBA User Manual Page 7
Mega Bar RGBA Operating Instructions
LED Display On/Off:
To set the LED display to turn off after 20 seconds, press the MODE and DOWN buttons
at the same time. Now the display will disappear after 20s. Press any button to turn the
display on again. To allow the display to stay On at all times, press the MODE and UP
buttons at the same time.
Operating Modes:
The Mega Bar RGBA has six operating modes:
• Sound-Active mode - The unit will react to sound, chasing through the built in
programs.
• Built-In Program - There are 22 built-in programs to choose from.
• Static Color Mode - There are 15 colors to choose from.
• Auto Mode - A auto program will run with adjustable fade speed.
• RGBA Mode - Choose one of the four colors to remain static or adjust the intensity
of each color to make your desired color.
• DMX control mode - This function will allow you to control each individual fixtures
traits with a standard DMX 512 controller.
Static Color Mode:
1. Plug the fixture in and press the MODE button until “C0.XX” is displayed.
2. There are 15 colors to choose from. Select your desired color by pressing the UP
and DOWN buttons. After you have selected your desired color you can activate
strobing by pressing the SET UP button to enter the Flash (strobe) mode.
3. “FS.XX” will now be displayed, this is Flash mode. The Flash can be adjusted
between “FS.00” (flash off) to “FS.99” (fastest flash).
RGBA Dimmer Mode:
1. Plug the fixture in and press the MODE button until “rgbA” is dis- played. Then
press the SET UP button to adjust intensity of the individual colors.
2. When “r.XXX” is displayed you are in Red dimming mode. Press the UP and DOWN
buttons to adjust intensity.
3. When “G.XXX” is displayed you are in Green dimming mode. Press the UP and
DOWN buttons to adjust intensity.
4. When “b.XXX” is displayed you are in Blue dimming mode. Press the UP and
DOWN buttons to adjust intensity.
To Next Page
Loading...
