ADJ Products, LLC - www.adj.com - Starbar Wash User Manual Page 18
Starbar Wash Operating Instructions
Color Change Mode and Color Fade Mode:
In this mode you can choose 1 of 10 color change programs or 1 of 10 color fade programs to run
.
The running speed of both programs are adjustable.
1. Plug the fixture in and press the MENU button until “CPXX” is displayed. “CP” is color change
mode and “XX” is the color change program number that is currently displayed.
2. Use the UP of DOWN button to find your desired color change program.
3. Press the MENU button again, and “FPXX” will be displayed. “FP” is color fade mode and “XX”
is the color fade program number that is currently displayed.
4. Use the UP of DOWN button to find your desired color fade program.
5. Press the MENU button again to access the program speed setting. “PS.XX” will now be displayed.
“XX” represents the current speed setting.
6. Use the UP and DOWN buttons to adjust the speed setting between “00” (slowest) to “16” (fastest).
The speed setting will be the same for both color change and color fade programs.
Sound Active Mode:
In this mode the Starbar Wash will react to sound, and chase through the different colors. There are 5
sound active modes to choose from with adjustable sound sensitivity.
1. Plug the fixture in and press the MENU button until “SoXX” is displayed. “XX” represents the
current sound active mode. Use the UP and DOWN buttons to find your desired sound active
mode.
2. Press the MENU button again to access the sound sensitivity adjustment setting. “SnXX” will
now be displayed. “XX” represents the current sound sensitivity level.
3. Use the UP and DOWN buttons to adjust the sound sensitivity level between “01” (least sensitive)
to “08” (most sensitive).
RGBW Dimmer Mode:
In this mode you can adjust the individual colors to make your desired color.
Adjustable strobing is
available for this mode.
1. Plug the fixture in and press the MENU button until:
2. “rXXX” is displayed you are in Red dimming mode. Use the UP and DOWN buttons to adjust the
intensity. After you have finished adjusting the intensity, or if you would like to skip to the next
color, press the MENU button.
3. When “GXXX” is displayed you are in Green dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
4. When “bXXX” is displayed you are in Blue dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
5. When “UXXX” is displayed you are in White dimming mode. Use the UP and DOWN buttons to
adjust the intensity.
6. Press the MENU button again to access the strobe setting. “S.FXX” will now be displayed. “XX”
represents the current strobe setting.
7. Use the UP and DOWN buttons to adjust the strobe rate between “00” (off) to “16” (fast strobing).
To Next Page
Loading...
