ADJ StarTec Series - ADJ UC Ir;Airstream IR Control

ADJ Products, LLC - www.adj.com - Starbar Wash User Manual Page 21
Starbar Wash UC IR and Airstream IR Operation
The ADJ UC IR (not included) infrared remote gives you control of various functions (See below).
To control the Starbar Wash you must aim the remote at the front or rear of the fixture bar and be no
more than 30 feet away. To use the ADJ UC IR you must first activate the fixtures infrared sensor. To
activate the sensor please see the instructions on page 19.
The ADJ Airstream IR remote transmitter (not included) plugs into the headphone jack of your iOS
phone or tablet. To control your fixture, raise the volume to the maximum level on your iOS phone or
tablet, aim the transmitter at the fixture sensor, and be no more than 15 feet away. The Airstream app
is a free download from the app store for your iOS phone or tablet. The app comes with 3 pages of
control depending on the fixture you are using. Please see below for IR functions including the
corresponding app page.
Standby
FullON Fade/Gobo 
Strobe Color 
1 2 3
4 5 6
7 8 9
SoundOn Show0 SoundO
Works with App page 1
STAND BY
Press this button to activate and deactivate remote control functionality.
FULL ON
Press this button to activate “full on”. Press any button to return to normal output/function.
FADE/GOBO
Press this button to activate and deactivate fade mode. Use the number buttons 1-9 to adjust the
speed.
DIMMER “+” and DIMMER “-”
Press these buttons to adjust the output intensity.
STROBE
Press this button to activate strobing. Press the button again to stop strobing. Use the number buttons
1-9 to adjust the strobe speed. “1” being the slowest, and “9” being the fastest.
COLOR
Press this button activate static color mode. Use the number buttons 1-9 to find your desired color.
1-9
These number buttons are used for fade speed, strobe speed, color selection, and show selection.
SOUND ON & OFF
These buttons activate and deactivate sound active mode.
SHOW 0
Press this button activate show mode. Use the number buttons 1-9 to find your desired show.