ADJ Products, LLC - www.adj.com - Starbar Wash User Manual Page 17
Starbar Wash Operating Instructions
Operating Modes:
The Starbar Wash has six operating modes:
• DMX control mode - This function will allow you to control each individual fixtures traits with a
standard DMX 512 controller.
• RGBW Dimmer Mode - Choose one of the four colors to remain static or adjust the intensity of
each color to make your own color.
• Sound Active mode - The unit will react to sound, chasing through the built in programs.
The sound sensitivity is adjustable
• Color Change Mode - There are 10 built-in color change programs to choose from. The color
change speed is adjustable.
• Color Fade Mode - There are 10 built-in color fade programs to choose from. The color fade speed
is adjustable.
• Color Macro Mode - There are 64 colors to choose from.
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Starbar Wash has 5 DMX modes: 4 Channel mode, 5 Channel
mode, 6 Channel mode, 17 Channel mode, and a 19 Channel mode. See pages 12-13 for the DMX val-
ues and traits.
1. This function will allow you to control each individual fixture’s traits with a standard DMX 512
controller.
2. To run your fixture in DMX mode press the MENU button until “XXXX” is displayed. “XXXX” represents
the current displayed DMX channel mode and address. Use the MENU button to find your
desired DMX channel modem and use the UP or DOWN buttons to find your desired DMX
address.
3. The Channel modes are listed below:
• To run the 4 Channel Mode, press the MODE button until “1XXX” is displayed. This is the
4 channel DMX mode and address setting.
• To run the 5 Channel Mode, press the MODE button until “2XXX” is displayed. This is the
5 channel DMX mode and address setting.
• To run the 6 Channel Mode, press the MODE button until “3XXX” is displayed. This is the
6 channel DMX mode and address setting.
• To run the 17 Channel Mode, press the MODE button until “4XXX” is displayed. This is the
17 channel DMX mode and address setting.
• To run the 19 Channel Mode, press the MODE button until “5XXX” is displayed. This is the
19 channel DMX mode and address setting.
4. Please see pages 12-13 for the DMX values and traits.
5. After you have chosen your desired DMX Channel mode and address plug in the fixture via the XLR
connections to any standard DMX controller.
Color Macro Mode:
In this mode you can choose 1 of 64 colors for output
. Adjustable strobing is available for this mode.
1. Plug the fixture in and press the MENU button until “CLXX” is displayed. “XX” is the color number
currently displayed.
2. There are 64 colors to choose from. Use the UP and DOWN buttons to find your desired color.
3. Press the MENU button again to access the strobe setting. “S.S.XX” will now be displayed. “XX”
represents the current strobe setting.
4. Use the UP and DOWN buttons to adjust the strobe rate between “00” (off) to “16” (fast strobing).
To Next Page
Loading...
