eP2 Controller LICENSE AGREEMENT
This is a legal agreement between you, the end user, and ADMET, Inc. (The Company). By using the eP2 Controller you are agreeing
to be bound by the terms of this agreement.
1.0 License Grant. The Company hereby grants the end user a personal, nontransferable and non-exclusive license to use one copy
of the software/firmware and related documentation on a single indicating system.
2.0 Intellectual Property Rights. The Company is the sole owner of all right, title and interest to the eP2 CONTROLLER and all
copyrights, trademarks, and trade secrets therein. The Company is protected by United States copyright laws and international
treaty provisions. Therefore, the end user must treat the software/firmware like any other copyrighted material and may not copy
the written materials accompanying the eP2 CONTROLLER.
3.0 Restrictions. This Agreement and the Licensed Software/Firmware may not be assigned, Sublicensed or otherwise transferred
by the Customer. The end user must not reverse engineer, decompile, or disassemble the Licensed Software/Firmware or attempt
to do so. The Licensed Software/Firmware may not be modified without the written consent of The Company.
4.0 Termination. The Company may terminate the license contained in this Agreement by written notice upon any breach of any
term by the end user. Upon termination, the end user shall immediately return the eP2 CONTROLLER to the factory. Section 2.0 of
this Agreement shall survive termination of this Agreement.
5.0 Purchase by Governmental Agencies. If the end user is a federal, state or local governmental agency or unit, then as a matter of
contract, the end user will accord The Company and the Licensed Program the same rights The Company would have had under the
Copyright Act of 1976, as amended.
6.0 Governing Law. This Agreement shall be governed by and construed in accordance with the laws of the Commonwealth of
Massachusetts.
To Next Page
Loading...
Need help?
General