IRF1000 series Instruction manual v1.3 11
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str.1 • 72622 Nürtingen • Germany
3.1 Safety instructions
To prevent damage to the device, all cable lines (power supply, interface cables) must
only be connected while the device is switched off.
All installation work performed on the device must be performed only under safe, secure
and de-energised conditions.
Always adhere to the safety measures applicable when handling components at
risk of being damaged by electrostatic discharges (EN 61340-5-1 / EN 61340-5-2).
3.2 Operating location
This device is designed for industrial use. Make certain that the specified environmental conditions are
maintained at all times. Use in non-specified environments, i.e., on board ships, in explosive
atmospheres or at extreme elevations, is prohibited. See also chapter 8 Technical data.
Damage caused by condensation!
To prevent short circuits and malfunctions caused by the formation of water condensate,
the device may only be turned on after it has reached the specified ambient
temperature. This also applies if the device is exposed to extreme temperature
fluctuations.
Damage caused by heat!
Do not expose the device to direct radiation by sunlight or any other light or heat
source!
3.3 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
To Next Page
Loading...