ADT Galaxy 16+ - Creating Tags

Creating Tags
When the keyprox is initially installed there will be no Tags programmed in to the
System. To do this proceed as follows;-
Step 1
Choose any Tag and hold it up to the keyprox for 10 Seconds. At which stage you
should get all the lights displayed. Remove the Tag from the keyprox.
Step 2
OnceyouhaveremovedtheTagfromthekeyprox.Allthelightswillstarttoashin
turn.(Red,Amber,Green&Orangelights).Atthisstagechoosewhichoneyou
want as the master Tag, and hold it up to the unit until the 3rdlightshows(Green)
Thenremove.Atthisstagethegreenlightwillstarttoash.
Step 3
With the 3rd(Green)lightashing.HoldthesameTagupagainuntilthe3rd(Green)
light shows again. You should now see the 3rd & 4thlightsash(Green&Orange).
This now means that this Tag is the Master Tag.
Note:
You need the Master Tag for entering programming to delete/add Tags.
Step 4
After a couple of seconds the 3rd & 4thlights(Green&Orange)willextinguishand
the1st&2ndlights(Red&Amber)willstarttoash.Thiswillallowyoutoprogram
the remainder of the Tags in to the System. Just present the Tag to the unit and
removestraightaway,youshouldget2beepsfromtheunit.Thisistheconrmation
that the Tag is now programmed in to the System.
Step 5
To exit programming mode, present any Tag that has been programmed up to the unit
5