ADT Galaxy 16+ - Deleting Tags

Deleting Tags
NOTE:
If you lose any Tags or need to delete any, you cant just delete one. You have to
delete all the Tags including the Master and start from the beginning.
Firstly this can only be done by the Master Tag. If you don’t have a master Tag
this will require an engineer to attend and delete all Tags.
Step 1
HoldtheMasterTaguptothekeyproxfor10 Seconds until the all the lights are
illuminated,andthenremovetheTag.Youshouldnowhaveallthelightsashingone
at a time.
Step 2
HoldtheMasterTaguptotheunitagain,untilthe4thlight(Orange)isilluminated
thenremove.Allthelightsshouldnowashandthenextinguish.Youhavenow
deleted all the Tags from the System.
Adding Additional Tags
Step 1
Enter programming mode by holding you Master Tag to the keyprox for 10 seconds,
until all the light illuminate
Step 2
Thenthelightsshouldashuponeaftereachother.Onceyougettothisstage
holdtheMasterTagbackupuntilthe3rd(Green)lightisilluminated,thenremove
the Tag. The 1st & 2nd (Red&Amber)lightsshouldstarttoash.
Step 3
OnceyougettothisstageyoucannowprogramtheremainderofyourTagsinto
the System. This is done by presenting each Tag up to the keyprox and removing it
straightaway.Youwillget2beepsasaconrmation.
Step 4
To exit programming mode, present any Tag that has been programmed up to the unit
6