ADT MDC845 FHD Wi-Fi Mini Dome Camera
Quick Installation Guide
MDC845 FHD Wi-Fi Mini Dome Camera Installation Guide
1 Introduction
This section provides information about the MDC845 FHD Wi-Fi Mini Dome
Camera's features, components and capabilities.
1.1 Feature Overview
The MDC845 is a Wi-Fi Mini Dome Camera with FHD resolution and 802.11ac Wi-
Fi connectivity intended for use with both ADT Control
®
and Pulse
®
.
• Standalone Design. The camera is a standalone system with built-in CPU
and video encoder. It requires only a power source and a connection to the
network (customer router for Control
or ADT Pulse gateway).
• Dual Video Support. The MDC845 supports H.264 and MJEPG video
compression.
• Day/Night Switch. With the day/night switching feature, you can view and
record images even at night.
• IR LED Support. The two infrared (IR) LEDs can provide illumination for up to
5 meters/16 feet, providing superior video quality under low-light conditions.
• Built-in Heater. The built-in heater ensures that the camera operates even
in extremely cold climates. The heater turns on when the temperature falls
below -4°F (-20°C).
• 802.11ac Support. The 802.11ac standard provides backward
compatibility with the 802.11 a/b/g/n standards.
• Supports Soft AP, WPS PIN, and Wired Enrollment. Software-enabled
Access Point (Soft AP) connectivity is used on the Control platform. Wi-Fi
Protected Setup PIN (WPS PIN) uses a push button and PIN to connect to
the Pulse platform. Both platforms support wired enrollment.
• Wireless and Wired Operation. The MDC845 operates either wired or wirelessly.
1.2 Physical Details
To Next Page
Loading...
Need help?
General
