ADT RC8025B-ADT User Manual

RC8025B-ADT Wireless Day/Night Camera Installation Guide
Rear Panel
Figure 2: Rear Panel
1. Power Port
This port is used to provide 12V to the wireless camera
from the supplied power adapter.
IMPORTANT
DO NOT USE ANY POWER ADAPTER OTHER THAN
THE ONE SPECIFIED FOR THIS CAMERA. DOING SO
MAY DAMAGE THE WIRELESS CAMERA.
2. Ethernet Port The Ethernet port enables connectivity of the wireless
camera to your ADT Pulse gateway.
IMPORTANT
• PLUGGING IN THE ETHERNET CABLE WILL
DISABLE THE WIRELESS INTERFACE. (ONLY ONE
INTERFACE CAN BE ACTIVE AT ANY TIME.)
• THE ETHERNET CABLE SHOULD ONLY BE
CONNECTED OR DISCONNECTED WHEN THE
DIGITAL CAMERA IS POWERED OFF. ATTACHING
OR DETACHING THE ETHERNET CABLE WHILE
THE CAMERA IS POWERED ON DOES NOT
SWITCH THE INTERFACE BETWEEN WIRED AND
WIRELESS.
• DETACHING THE ETHERNET CABLE WHEN THE
OUTDOOR DIGITAL CAMERA IS POWERED ON
WILL DISCONNECT THE OUTDOOR DIGITAL
CAMERA FROM THE NETWORK.
4 ADT Pulse
®
Interactive Solutions

ADT RC8025B-ADT Specifications

General

Brand	ADT
Model	RC8025B-ADT
Category	Security Camera
Language	English