Installation
The following instructions provide details of configuring and installing the
RC8025B-ADT Wireless Day/Night Camera to your ADT Pulse network.
Configuring and Installing the RC8025B-ADT
Initial setup is performed only one time to configure the camera’s wireless
settings to the ADT Pulse Gateway.
Figure 3: Initial Setup
1. Assemble the Camera
Attach the Camera Stand to the camera.
2. Connect the LAN Cable
Connect the wireless camera to a 10/100BaseT hub or switch, using a
standard LAN cable.
3. Power Up
Connect the supplied 12Vpower adapter to the wireless camera and power
up. Use only the power adapter provided. Using a different one may cause
hardware damage.
• The Power LED turns on briefly, and then starts blinking. It blinks during
startup, which takes 60 to 90 seconds. After startup is completed, the
Power LED remains ON.
• The Network/WPS LED turns ON.
To Next Page
Loading...
