What to do if POTS LED is red on ADTRAN Network Hardware?
If the POTS LED on your ADTRAN Network Hardware is red, first contact the OLT administrator to ensure the port is provisioned and working. Next, disconnect the CPE wiring for 30 seconds; if the LED turns off, there's likely a short in the housing wiring. If the LED remains red, the unit might be faulty.
What to do if LEDs on the front of ADTRAN SFU ONT Network Hardware cycle continuously?
If the LEDs on the front of your ADTRAN SFU ONT Network Hardware cycle continuously, try using a different SFU ONT. Also, ensure that the power supply is functioning correctly.
Why is the network status LED red on my ADTRAN Network Hardware?
If the network status LED on your ADTRAN Network Hardware is red, contact the Central Office. There may be a software configuration issue between the OLT and the SFU ONT.
How to fix network status LED off on ADTRAN Network Hardware?
If the network status LED on your ADTRAN Network Hardware is off, check all fiber connections to make sure they are clean and tight.
What to do if the upstream optical signal level is out of range on ADTRAN Network Hardware?
If the upstream optical signal level is out of range on your ADTRAN Network Hardware, first verify the ONT provisioning at the OLT. If the problem persists after verification, consider replacing the ONT.
What to do if network status LED continually flashes yellow on ADTRAN Network Hardware?
If the network status LED on your ADTRAN Network Hardware is continually flashing yellow, contact the Central Office.
General| Brand | ADTRAN |
|---|---|
| Model | Total Access 324 |
| Category | Network Hardware |
| Language | English |
To Next Page
