• Step 7 – Configuring the OsmoTECH settings
• Review and/or configure the following instrument settings before using the OsmoTECH. Refer
to the User Guide for instructions.
• If the date or time displayed on the unit is incorrect, set the current date and time.
• If synchronizing the clock, configure the OsmoTECH to connect to your local area network (LAN).
−To use DHCP (dynamically assigned IP):
− Connect the OsmoTECH to the network
− Enable the “Time Server” in the Date & Time screen
− Select the time zone location
− Enter a server name of choice
− To use Static IP:
− Connect the OsmoTECH to the network
− Enable the “Time Server” in the Date & Time screen
− Select the time zone location
− Enter a server name of choice as a numerical value
− Set the Subnet Mask in the LIS/LAN screen to match the local network value
− Set the Default Gateway in the LIS/LAN screen to match the local network value
Installation and Setup
To Next Page
