Need help?Do you have a question about the Advanced Instruments Osmo1 and is the answer not in the manual?
General| Brand | Advanced Instruments |
|---|---|
| Model | Osmo1 |
| Category | Medical Equipment |
| Language | English |
Contact information for technical support and service issues, including hours and methods.
Lists instrument parts with their part numbers and corresponding replacement procedures.
General warning to read and observe all precautions to prevent injury, shock, fire, or damage.
Cautions regarding unplugging power, qualified technicians, airflow, static discharge, and fuse replacement.
Warnings about handling biohazardous materials, PPE, and decontamination procedures.
Details the required power source, grounding, and outlet specifications for the instrument.
Explains how to correctly place the Micro-Sample Test Kit for optimal testing.
Emphasizes using only Advanced Instruments calibration standards for accurate results.
Lists conditions and scenarios that necessitate recalibrating the Osmo1 instrument.
Guides the user through the step-by-step process of calibrating the Osmo1.
Lists common calibration errors and provides suggested causes and actions for resolution.
Guides on how to access the instrument's settings menu via the Home and Main menus.
Explains the login procedure required to access and modify instrument settings.
Guides on adjusting probe resistance, noting it requires recalibration if changed.
Provides instructions for configuring the Osmo1 to communicate with a Laboratory Information System (LIS).
Step-by-step guide to configure the LIS connection, including IP address and port settings.
Guides on enabling and configuring the Osmo1's Local Area Network (LAN) connection for communication.
Details the process for updating the instrument's software and firmware using a USB drive.
Explains how to set user-level restrictions for functions like language, LIS/LAN, and calibration.
Guides on accessing the Diagnostics menu from the Home and Main screens.
Checks the status of the Micro-Sample Test Kit consumables, like sampler tip count.
Provides general cleaning and maintenance advice for the Osmo1 instrument.
Important safety cautions to unplug power, handle static discharge, and use qualified technicians.
Guidance on inspecting, cleaning, or replacing the solenoid to ensure accuracy and repeatability.
Provides instructions for replacing the sampler plunger wire to maintain instrument accuracy.
Procedure to verify the sampler's calibration after wire replacement or periodically.
Refers to Appendix I for instructions on replacing defective parts and instrument cover removal.
Lists general errors detected by the system and their suggested actions for resolution.
Refers to Table 5 for a list of errors that can occur during the calibration process.
Lists errors that occur during sample testing and provides possible causes and suggested actions.
Provides troubleshooting guidance for electro-mechanical issues, such as power loss or probe errors.
Lists symptoms, possible causes, and suggested actions for electro-mechanical problems.
Specifies the instrument's accuracy and within-run repeatability using standards.
Details the requirements for configuring Osmo1 for LIS communications, including LAN setup.
To Next Page
