4.4 OPTIONS INDEX
The following programmable options and settings are available.
Set the fault buzzer volume to high or low
Remove all disablements which have been set for
any zone, sounder circuit, output or delay
Initialise Factory Settings
Restores all programming, test modes and
disablements back to factory default settings
• Change/remove keypad access code
• Set quantity of repeater panels on system
• Set panel delay time
• Disable battery monitoring
• Set panel internal PCB config (adding additional
zone cards or repeater comms PCB)
• Set repeater comms monitoring type
• Set zone to latching or non-latching
• Set zone to old B.S (short circuit = fire)
• Set zone for use with MTL5061 I.S. barrier
• Set zone to silent mode (provides visual & audible
indication at the panel but no sounder operation)
• Turn off priority alarm feature for zone
• Turn off detector removal monitoring for zone
• Set detector removal monitoring type for zone
(Schottky or Zener diode detector bases)
Set panel & zones to dependency mode A, B or C
EN54 Sounder Resound
Options
Set zones to not resound alarms after an initial fire
condition
Apply delays to outputs in response to selected
zones
Change the default functions of the Class Change
and Alert inputs
Output Programmability &
Miscellaneous
Set panel outputs to be programmable, switch on
fault latching, invert fault output
Set how each output or sounder circuit responds for
each zone (off, continuous or pulsing)
Quick set codes for zone of origin or zonal sounder
ringing for Twin Wire sounder circuits
Output Functional
Options
Change the default output responses to ‘Silence
Alarms’, ‘Evacuate’, ‘Class Change’, ‘Alert’ and
‘Delay’
Tests system PCB config setup for fault diagnosis
Repeater panel setup & programming
www.acornfiresecurity.com
www.acornfiresecurity.com
To Next Page
Loading...
Need help?
General
