To Next Page

To Previous Page

Set Fault Buzzer Volume

There are two levels of volume for the internal fault buzzer, high

and low.

Enter the above code and press the ENTER button to increase or

decrease the fault buzzer tone from the previous level.

Setting will change when ENTER button is pressed.

When finished, enter the next programming code or disable the controls and return DIL switch 6 to ‘OFF’.

Clear All Disablements

Enter the above code and press the ENTER button.

Then press the ENTER button again and hold for 3 seconds.

Any disabled zone, sounder circuit, output or delay will now be

enabled.

The panel will bleep to acknowledge the reset.

When finished, enter the next programming code or disable the controls and return DIL switch 6 to ‘OFF’.

Initialise Factory Default Settings.

Enter the above code and press the ENTER button.

Then press the ENTER button again and hold for 3 seconds.

Any disablements or test mode settings will now clear and all

engineering option parameters will revert back to factory settings.

The panel will bleep to acknowledge the reset.

When finished, enter the next programming code or disable the controls and return DIL switch 6 to ‘OFF’.

Advanced Quick Zone XL User Manual

Questions and Answers: