Advantech Adam 4000 Series - Page 123

Chapter 4 Command Set 4-39
Chapter 4
Command Syntax Command Name Command Description Page No.
@AAEAT Enable Alarm Enable the alarm in either
momentary or latching mode
432
@AADA Disable Alarm Disable all alarm functions 4 213
@AACA Clear Latch Alarm The latch alarm is reset 4 214
@AAPA(data) Set Low-Alarm Count
Value of Counter 0
Downloads the low-alarm count
value for counter 0 of the
specified counter/frequency
module
4 215
@AASA(data) Set High-Alarm Count
Value of Counter 0
Downloads the high-alarm count
value for counter 0 of the
specified counter/frequency
module
4 216
@AARP Read Low-Alarm
Count Value of
Counter 0
Ask the addressed module to
return its low-alarm count value
for counter 0
4 217
@AARA Read High-Alarm
Count Value of
Counter 0
Ask the addressed module to
return its high-alarm count value
for counter 0
4 218
@AADO Set Digital Output
Values
Set the values of the module’s
two digital outputs
(ON or OFF)
4 209
@AADI Read Digital Output
and Alarm Status
Ask the addressed module to
return the state of its two digital
output channels and the status
of its alarm
4 210