Advantech Adam 4000 Series User Manual

Command Set
4-4 ADAM 4000 Series User's Manual
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Sets the address, input range,baud
rate, data format, checksum status,
and/or integration time for a specified
analog input module
444
#AA Analog Data In Returns the input value from a
specified analog input module in the
currently configured data format
452
$AA0 Span Calibration Calibrates an analog input module to
correct for gain errors
457
$AA1 Offset Calibration Calibrates an analog input module to
correct for offset errors
458
#** Synchronized
Sampling
Orders all analog input modules to
sample their input values and store
them in special registers
459
$AA4 Read Synchronized
Data
Returns the value that was stored in
the specified module’s register after
the #** command
460
$AA2 Configuration Status Returns the configuration parameters
for the specified analog input module
448
$AA3 CJC Status Returns the value of the CJC sensor
for a specified analog input module
463
$AA9 CJC Offset Calibration Calibrates the CJC sensor for offset
errors
464
$AAF Read Firmware
Version
Return the firmware version code from
the specified analog input module
450
$AAM Read Module Name Return the module name from the
specified analog input module
451
4.3 I/O Module Commands Search Table
(continued on following page)
ADAM-4011 Command Table

Advantech Adam 4000 Series Specifications

General

Brand	Advantech
Model	Adam 4000 Series
Category	Control Unit
Language	English