Advantech Adam 4000 Series - Page 241

Chapter 4 Command Set 4-157
4050, 4052, 4053, 4060, 4051, 4055, 4068
Chapter 4
4050, 4060, 4055, 4068
#AABB
Response >(cr) if the command was valid.
?AA(cr) if an invalid command has been issued.
There is no response if the module detects a syntax error or
communication error or if the specified address does not exists.
> delimiter character indicating valid command was received.
? delimiter character indicating the command was invalid.
AA (range 00-FF) represents the 2-character hexadecimal
address of the digital I/O module that is responding.
(cr) is the terminating character, carriage return (0Dh).
Examples command: #140005(cr)
response: >(cr)
An output byte with value 05h (00000101) is sent to the digital
I/O module at address 14h (Either ADAM-4050 or ADAM-
4060). Its channels 0 and 2 will be set to ON. Other channels are
set to OFF.
command: #151201(cr)
response: >(cr)
An output bit with value 1 is sent to channel 2 of a digital I/O
module at address 15h (Either ADAM-4050 or ADAM-4060).
Channel two of the digital I/O module is set to ON.