Need help?Do you have a question about the Advantech Adam - 4068 and is the answer not in the manual?
General| Model | ADAM-4068 |
|---|---|
| Input Channels | 8 |
| Communication Interface | RS-485 |
| Power Consumption | 1.2 W |
| Protocol | Modbus RTU |
| Power Supply | 10 to 30V DC |
| Operating Temperature | -10 to 70°C (14 to 158°F) |
| Storage Temperature | -25 to 85 °C |
| Humidity | 5 ~ 95% RH, non-condensing |
Details the essential hardware and software components needed to set up and configure an ADAM network environment.
Explains the initial module configuration and basic hook-up procedures for connecting ADAM modules to host switches.
Describes how to set and change baud rate and checksum parameters, which require the module to be in INIT* state.
Provides a Visual Basic 6.0 programming example demonstrating how to get temperature readings from an ADAM-4011 module.
Provides specifications for ADAM-4017/4017+, ADAM-4018/4018+, and ADAM-4018M analog input modules.
Explains the ADAM-4019+ universal analog input module, integrating various AI modules for cost and wiring simplification.
Details the ADAM-4080/4080D modules with 32-bit counters and programmable timer for frequency measurement.
Explains the general syntax and structure of commands used for communicating with ADAM modules.
Provides a common command set applicable to multiple ADAM analog input modules, covering configuration and data retrieval.
Details the specific commands for configuring and controlling the ADAM-4021 analog output module.
Explains the commands for the ADAM-4024 analog output module, including its multi-range AO support.
Covers commands for digital I/O and relay output modules, including data input, output, safety values, and status.
Details commands for counter/frequency modules, covering configuration, input modes, and digital filter settings.
Explains the software-based calibration process for analog input modules, including zero and span calibration.
Describes the calibration process for analog output modules, covering ranges and using the utility software for trimming and calibration.
Lists the technical specifications for the ADAM-4019+ 8-channel universal analog input module.
Details the technical specifications for the ADAM-4080 counter/frequency input module.
Provides the technical specifications for the ADAM-4080D counter/frequency input module with LED display.
Guides users through the ADAM-4000 utility software for module configuration, calibration, and data input/output.
Provides a step-by-step guide for the initial installation and configuration of ADAM-4000 modules.
Explains the EIA RS-485 standard, its specifications, and how ADAM modules utilize it for communication.
Illustrates common network layouts for multi-drop RS-485 systems, including daisychain and star configurations.
Guides on enabling and disabling the checksum feature for communication error detection between host and module.
Outlines the steps to configure ADAM-4000 modules for Modbus protocol, replacing the default ADAM ASCII protocol.
To Next Page