Need help?Do you have a question about the Advantech Adam-4012 and is the answer not in the manual?
General| Type | Analog Input Module |
|---|---|
| Channels | 8 |
| Resolution | 16-bit |
| Communication | RS-485 |
| Protocol | Modbus RTU |
| Power Supply | 10-30 VDC |
| Isolation Voltage | 3000 VDC |
| Input Range | 4-20 mA |
| Sampling Rate | 10 samples per second (per channel) |
| Operating Temperature | -10°C to +60°C (14°F to 140°F) |
| Accuracy | ±0.1% of FSR |
| Storage Temperature | -40 to 85 °C |
| Humidity | 10 to 90% RH |
Describes the intelligent sensor-to-computer interface modules, their remote control via RS-485, and key functions like signal conditioning and A/D conversion.
Details the necessary hardware and software components for setting up an ADAM network environment, including modules, host computer, and converters.
Explains the fundamental steps for configuring ADAM modules, including default settings and basic connection diagrams for host setup.
Describes various analog input modules, including their features, input types, and specifications.
Details the ADAM-4016 strain gauge input module, its excitation voltage output, and digital output capabilities.
Covers 8-channel analog input modules, including differential and thermocouple types, and data logger functionality.
Describes the ADAM-4019 universal analog input module that integrates multiple AI types, reducing cost and simplifying wiring.
Explains the ADAM-4021 analog output module, its digital input, output signals, and slew rate configuration.
Details various digital I/O modules, including isolated and non-isolated types, and their channel configurations.
Describes relay output modules, their contact ratings, and suitability for ON/OFF control applications.
Covers counter/frequency input modules, including signal input modes, digital filters, and programmable thresholds.
Details commands specific to analog input modules, including configuration, data reading, and calibration.
Lists commands for analog output modules, covering configuration, data output, and calibration.
Details commands for counter/frequency modules, including configuration, setup, and digital filter settings.
Explains the software-based calibration process for analog input modules, including warm-up and applying voltages.
To Next Page