Need help?Do you have a question about the Advantech Adam-4016 and is the answer not in the manual?
General| Input Channels | 16 |
|---|---|
| Analog Input | Yes |
| Resolution | 16-bit |
| Communication | RS-485 |
| Protocol | Modbus RTU |
| Isolation Voltage | 3000 VDC |
| Input Type | mV, V, mA |
| Input Range | 0 to 20 mA, 4 to 20 mA |
| Accuracy | ±0.1% of FSR |
| Sampling Rate | 10 samples/second (total) |
| Power Supply | 10 to 30 VDC |
| Operating Temperature | -10°C ~ +60°C (14°F ~ 140°F) |
| Storage Temperature | -25 ~ 85 °C (-13 ~ 185 °F) |
| Humidity | 10 ~ 95% RH (non-condensing) |
| Weight | 300 g |
Provides a general description of the ADAM Series modules, their features, and power requirements.
Explains the default factory settings and the basic procedure for configuring and connecting ADAM modules.
Covers the process of setting the baud rate and enabling/disabling the checksum feature for reliable communication.
Describes the functionality and specifications of various ADAM analog input modules, including thermocouple and RTD types.
Covers 8-channel analog input modules, including differential and thermocouple types, and data logger functionality.
Describes various ADAM digital I/O modules, including isolated and non-isolated types, and their channel configurations.
Covers counter and frequency input modules, including programmable digital filters and thresholds for signal processing.
Provides a comprehensive table listing commands for different I/O modules, including their syntax and function.
Details the command set specific to analog input modules, covering configuration, data reading, and calibration.
Outlines the commands for configuring and controlling ADAM analog output modules, including calibration and data output.
Lists commands for controlling digital I/O and relay output modules, covering data input/output and status checks.
Details commands for counter and frequency modules, including configuration, setup, and data retrieval.
Explains the software-based calibration procedures for ADAM analog input modules, including zero and span calibration.
Describes the process for calibrating ADAM analog output modules, focusing on setting output values for current and voltage ranges.
Explains the different data formats for analog input modules, including Engineering Units, Percent of FSR, and Twos Complement Hexadecimal.
To Next Page