Need help?Do you have a question about the Advantech Adam - 4050 and is the answer not in the manual?
General| Product Type | Digital I/O Module |
|---|---|
| Channels | 8 |
| Digital Inputs | 4 |
| Communication Interface | RS-485 |
| Isolation Voltage | 3000 VDC |
| Humidity | 5 ~ 95% RH, non-condensing |
| Protocol | Modbus RTU |
| Operating Temperature | -10 ~ 70 °C |
| Storage Temperature | -25 ~ 85 °C |
| Input Voltage Range | 10 ~ 30 VDC |
Lists necessary hardware and software components for setting up an ADAM network, including host computer and power supply.
Explains default factory settings and basic procedures for configuring ADAM modules, including the hook-up scheme.
Details how to change baud rate and checksum settings, including the INIT* state and module reboot.
Details the syntax structure for ADAM commands, including delimiter, address, command, data, and checksum format.
Instructions for calibrating analog input modules using software and hardware setup, including zero and span calibration.
Calibration steps for ADAM-4015T thermistor modules, including lead wire effect compensation and zero/span calibration.
Instructions for calibrating analog output modules using low and high calibrating values, including trim and mA calibration.
Step-by-step guide for installing and configuring ADAM-4000 modules, including wiring and initial setup procedures.
Step-by-step guide to configure ADAM-4000 modules for Modbus protocol using the utility software.
To Next Page