37 EKI-1521/1522/1524 User Manual
Chapter 3 Configuration
The default value is 1000 ms.
Example: <Guard Time> + <Guard Time> + <Guard Time> +
The following commands are available for EKI-1500 series.
Table 3.1: AT Command List
Command Function
ATDT<IP address> <TCP port>
<CR>
“Forms a TCP connection to the specified host.
Ex: ATDT 192.0.55.22:5201
In above example, the EKI serial device server forms
a raw TCP connection to the networking device
(192.0.55.22). The TCP port is 5301.”
ATA <CR> Answering an incoming call
+++<CR> Returns the user to the command prompt when
entered from the serial port during a remote host con-
nection.
<LF><CR> OK <LF><CR> Commands are executed correctly
<LF><CR> CONNECT <LF><CR> Connect to other device
<LF><CR> RING ddd.ddd.ddd <LF><
CR>
Detect the connection request from other device,
which IP address is ddd.ddd.ddd.ddd.
<LF><CR> DISCONNECT
<LF><CR>
Disconnect from other device
<LF><CR> ERROR <LF><CR> Incorrect commands
<LF><CR> FAIL <LF><CR> If you issu an ATDT command and can not connect to
the device, it will response “FAIL”.
To Next Page
Loading...
