Advantech ICAM-520 Series - Page 31

21 ICAM-520/500 User Manual
Chapter 4 Getting Started
Options
ipcfg --nic-list List local network interfaces.
ipcfg -C [cmd] Run commands (see Commands section)
ipcfg -C [cmd] --remote-mac [MAC] Configure remote device with MAC address.
ipcfg -C [cmd] --local-address [IP address] Configure specified NIC with the IP
address.
ipcfg -C [cmd] --local-device [dev_name] Configure device named [dev_name].
ChangeNetwork
Set network parameters.
Config device network to DHCP
ipcfg -C ChangeNetwork DHCP
Config device network to static IP ?IP Netmask Gateway)
ipcfg -C ChangeNetwork STATIC 192.168.0.100 255.255.255.0 192.168.0.1
ChangeDevName
Chage device identify name in discovery utility.
ipcfg -C ChangeDevName A-0011 --remote-mac 001122334455
User can configure and set up the ICAM-ICAM-500 via web server. The web server is
accessed form a host windows 10 OS PC using Google Chrome as follower. Please
connect your host PC and ICAM-500 in your local networking area.
1. Open Google Chrome on the configured PC connected to the ICAM-500.
2. Change the Network segment of Host PC and enter the IP address of the ICAM-
500: 192.168.0.100:5000
3. Then ICAM-500 web server interface will be displayed in the Chrome browser.