• Verify that the router model supports serial communications. Also verify the serial communica-
tion settings. To do so, open the router’s configuration menu via the web browser, select the
appropriate "Expansion Port" from "Configuration" part of the menu and verify the settings.
✍ Is the router Cisco compatible? Can I use the Cisco configuration?
• No, the Firmware in the router (Conel OS) is based on Linux with BusyBox. Thus the Cisco
configuration cannot be used. But network connections are defined by standards so connecting
the router to the Cisco or other networking devices is possible and will be compatible.
✍ FTP or SFTP does not work
• FTP will work on v2 routers only. You can use SFTP on all routers to transfer files to/from the
router. If having troubles with FTP on v2 routers, make sure you have FTP enabled: "Configu-
ration" section, "Services", "FTP". Then you can connect with any client on port 21 with name
and password same as for the Web interface. If having troubles with SFTP, make sure you have
SSH enabled: "Configuration" section, "Services", "SSH". Then you can connect with any client
on port 22 with name and password same as for the Web interface.
✍ How can I connect to the router’s command line? (SSH, Telnet)
• You can use SSH on all routers or Telnet on v2 routers only. SSH is enabled by default, but you
can verify in Web interface in "Configuration" section, "Services", "SSH". Then connect with any
SSH client on port 22 of the router. User and password is the same as for the Web interface.
Telnet on v2 routers can be enabled here: "Configuration" section, "Services", "Telnet".
ICR-2701 Hardware Manual (preliminary version) 24
To Next Page
Loading...
Need help?
General
