vii MIC-770 V2 User Manual
Safety Precautions
Packing List
Before system installation, check that the items listed below are included and in good
condition. If any item does not accord with the list, contact your dealer immediately.
Warning! Always completely disconnect the power cord from your chassis when-
ever you work with the hardware. Do not make connections while the
power is on. Sensitive electronic components can be damaged by sud-
den power surges. Only experienced electronics personnel should open
the PC chassis.
Caution! Always ground yourself to remove any static charge before touching the
motherboard. Modern electronic devices are very sensitive to static
electric discharges. As a safety precaution, use a grounding wrist strap
at all times. Place all electronic components on a static-dissipative sur-
face or in a static-shielded bag when they are not in the chassis.
Caution! The computer is provided with a battery-powered Real-time Clock cir-
cuit. There is a danger of explosion if battery is incorrectly replaced.
Replace only with same or equivalent type recommended by the manu-
facturer. Discard used batteries according to manufacturer’s instruc-
tions.
Caution! There is a danger of a new battery exploding if it is incorrectly installed.
Do not attempt to recharge, force open, or heat the battery. Replace the
battery only with the same or equivalent type recommended by the man-
ufacturer. Discard used batteries according to the manufacturer’s
instructions.
MIC-770 V2 bare-bone system x 1
Startup manual EN\CN\TC for MIC-770 V2 1st Ed P/N: 2041077030
4-pin Phoenix connector P/N: 1652003234
Mounting bracket x 2 P/N: 1960070543T005
SATA cable x 1 P/N: 1700013095
SATA Power cable x 1 P/N: 1700024372-01
CPU thermal grease x 1 P/N: 2170000093-01
RAM thermal pad x 2 P/N: 1990019498N000
To Next Page
Loading...
Need help?
General
