5.6 Changing the Maximum Call Time
The maximum time limit for an answered call is set using the CTIME command. The de-
fault time limit is 45s. The CTIME command is specified in seconds and can be set from 1s
to 255s.
CTIME 45. sets the maximum call time to 45 seconds
5.7 Changing the Maximum Line Silence Time
The maximum time for which a silent call will remain connected is set using the SILENCE
command. This is useful were a call may be redirected to voicemail. The silence during
recording will cause the system to hang the call. The default silence time is 15s and can
be set from 1s to 255s.
STIME 25. sets the maximum line silence time to 25 seconds
5.8 Adding Auto-dialler SMS Text Numbers
The system can send the input triggered message (2.16) to up to all 511 numbers. To add
a text number the following SMS text message is sent to the system by any master num-
ber:
TEXTNUM<space>number.
e.g. textnum 07000000000.
5.9 Adding Auto-dialler Call Numbers
The system can call up to all 511 numbers when the input is triggered. To add a call num-
ber the following SMS text message is sent to the system by any master number:
CALLNUM<space>number.
e.g. callnum 07000000000.
5.10 Assigning a Number to Specified Channel Only
Both Call and Text Numbers can be assigned to call/text only when one particular chan-
nel is activated. This is done by appending A or B to the CALLNUM and TEXTNUM com-
mands as follows:
CALLNUMA 07000000000 calls the number 07000000000 only when channel A is active
TEXTNUMB 07000000000 texts the number 07000000000 only when channel B is active
N.B. Text/Call numbers can also activate the output—there is no need to ADD the number
It is important to know that channels A&C and analogue input 1 are common. Numbers
specified for channel A will also be sent message/dialled when input C and analogue
input 1 are triggered. Similarly input B shares its number with D and analogue input 2.
To Next Page
Loading...
Need help?
General
