battery!
CAUTION: Use only factory supplied or authorized SNMP monitoring cable!
1.3.3 OUTPUT POWER RECEPTACLES
1.3.4 AC INPUT POWER RECEPTACLE
1.3.5 INPUT CIRCUIT BREAKER/ FUSE
It trips when the connected loads exceed the protected receptacle‘s capacity, The center
plungers of the circuit breakers/ fuse extend when tripped.
1.3.6 SITE WIRING FAULT INDICATORS (RED LED)
It comes on when the UPS is connected to an improperly wired AC power outlet.
Note: This device is available on 110 Vac model only.
1.3.7 COMPUTER INTERFACE
Provide both RS-232 and relay signal to support NOVELL, UNIX, DOS, WINDOWS and
other operating systems.
1.3.8 SNMP INTERFACE PORT (optional)
Provide the SNMP adapters for 10-BaseT Ethernet and Token Ring connectors. Through
RS232 communication port, the SNMP adapter make your UPS becomes “SNMP
manageable”, provide a real time UPS and power status information for the network
manager.
Note: It‘s not necessary to use this function
.
To Next Page
Loading...
