EasyManua.ls Logo

AEG BE2000000 - Oven Ceiling; Oven Door and Glass Panels

AEG BE2000000
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Turn the lamp glass cover counterclockwise to remove it.
2. Clean the glass cover.
3. If necessary, replace the oven lamp with applicable 300°C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
Oven Ceiling
You can fold down the heating element on the oven ceiling to clean the oven ceiling easily.
WARNING!
Before you fold down the heating element deactivate the appliance. Make sure that the
appliance is cold. There is a risk of burns!
Folding down the heating element
1. Remove the shelf support.
2. Hold the heating element with the two
hands at the front
3. Pull it forwards against the spring pres-
sure and out along the support on both
sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in opposite
sequence.
Install the heating element correctly on the two sides above the support on the inner
wall of the appliance.
2. Install shelf support.
Oven door and glass panels
To clean the oven door remove it.
CAUTION!
Be careful when you remove the door from the appliance. The door is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
20
Care and cleaning

Related product manuals