AEG COMPETENCE 770 E-mp - Safety Instructions

SI 2/89 GB/EU- SIB2 4/89 GBYEU- SIB4-1.9/90 GEYEU-SIB6-2 1/92 GBYEU
Safety instructions
The safety requirements oblige manufacturers to give the following
instructions:
For installation in a kitchen unit, my attached installation instructions
must be noted.
- Should any fractures, cracks, or other defects appear in my
high-grade glass-ceramic oven ceiling, please immediately
stop using my oven.
For your additional safety against any subsequent switch-
on, remove my cooker fuses or switch off the automatic
safety system. Please notify promptly the service centre
covering your area.
- If you use my oven space divider, the heated oven space
divider should only be placed in my oven complete {lower
part with heating element and cover).
- Whenyou use meto prepare your food, my hobs and/orthe oven
door become hot. Therefore keep smail children well away from
me.
- This especially applies when you are grilling or pyrolytically
cleaning my oven {if available).
- Overheated fats and oils rapidly ignite. When using me to pre-
pare food in fat or oil (e.g. chipped potatoes), please remain
nearby.
~ Do not use me to heat your room.
- Take care when connecting electrical appliances to plug sockets
in the cooker vicinity. Connection leads should not come within
reach of hot hobs/cooking zones or get trapped under the hot
oven door.
- To avoid damage to my glass-ceramic surface, you should not
use my cooking area as a storage area.
- Donotplace any hot frying pans or saucepans on the edgeof
the cooking area as this can cause damage.
- Never cover my cooking surface with protective foil. This can
cause damage.
- The glowing red heat of my cooking zones can shine out over the
edge of the marked zone, according to the angle at which you
look at it.
~ My glass-ceramic cooking area (where featured) is extremely
resistant, though not unbreakable. It may be damaged by any
sharp or hard objects falling on to the cooking surface.
Should any fractures, cracks, or other defects appear, | must be
separated from the mains supply by the device required on the
fixed wiring side. Before doing so, please switch my 4 hob
switches to 0.
- Never line my oven floor with aluminium foil and never place any
pan, pot, etc. on my ficor, since the oven enamel will otherwise be
damaged by the heat congestion caused.
For the
installer
For the
user
53