AEG COMPETENCE 770 E-mp - What to Do if

Faults
you can rectify
yourself
98
What to do if...
... the pilot lamps do not show?
«+. the oven does not heat?
1. You may well have not operated all relevani switches or
2. the fuse on the fixed wiring side (safety box) has blown.
3. Important: Please make sure that my oven door is fully
closed! ‘
... the fuses keep blowing?
Please cali an approved electricat! installer.
...the oven lighting fails?
See Cleaning and care on page 95.
Failure of my oven lamp(s) does not fall under the guarantee.
«+. the oven cannot be switched on?
Check whether:
.. My time of day is flashing in the display!
If yes, reset my time of day.
... the audible tone of my timer is emitting a continuous tone.
Then press the corresponding button to switch it off!
. my timer display does not show, but the pilot lamps of the
appliance stili show?
... incorrect indications appear in my display?
.. duration and end cannot be entered!
An operating fault has occurred in my timer, or else there has
been a short-term power failure.
Then remove/unscrew the wiring fuses of the appliance, wait
30 seconds, and then switch on/screw in the wiring fuses
again.
Then reset the time of day in my electronic timer.
... the function indicator pilot lamps of the automatic induction
hobs flash?
»..an intermittent or continuous audible tone sounds?
... See user safety instructions referring to the induction hobs.
li, however, you decide io call in the service centre to help with any of
the stated instructions or on grounds of faulty operation, the service
engineer's visit cannot be made free of charge even during the gua-
rantee period.
AEG electrical appliances comply with the valid safety require-
ments. Repairsto electrical appliances should only be performed by
a trained electrician. improper repairs may place the user at serious
tisk.
WIW1-1 9/80 GEVEU- WTW2 2/89 GBVEU- WTWS-1 7/60 GBYEU-WTW4.2 11/80 GBVEU- WTwi0 4/88 GB/EU