AEG COMPETENCE 770 E-mp - Operating the Hobs

KB1-1 8/90 GBVEU-KB3-22/91 GBVEU
After switching on a cooking zone, you will hear me buzz. This is a
feature of my radiant heating system not in any way impair my ope-
ration!
Never place food in aluminium foil or plastic containers on my hot
cooking area, since that will have an extremely detrimental effect on
the glass-ceramic cooking suriace!
You can also use my automatic hobs without the automatic system.
You should then switch me on only as far as setting 9.
When starting to fry, set the switch referring to the hob to 9 until the
fatis hot. Then place the food to be fried in the pan and turnthe switch
back to 6 or higher as necessary.
When starting to boil, setthe switch referring to the hobto 9. To sim-
mer, turn the switch back to 1 to 5 as necessary.
Intermediate settings, e. g. 3. (or * 2 only with electronic indicator),
are at all times possible.
When starting to boil within the 1-8 region {not on setting 9), my
automatic system relieves you of the need to switch over to my sim-
mering region ifyou turn the knob clockwise beyond setting 9 as far
as letter A (the pilot lamp monitoring the boiling-up sequence
comes on - if available) and then setit back to the required simmer-
ing region (1-8).
My automatic system selects for you the boiling-up time at the
start of cooking and then itself switches back the power corre-
sponding to the simmering setting selected.
The automatic system and/or the hob is switched off by iurning to 0.
The follawing table shows you examples of the suitability of switch
settings 1 to 9.
Operating the
cooking zones
- beforehand
- Boiling/
frying on the
automatic heb
Without the
automatic
system
With the
automatic
system
67