AEG COMPETENCE 770 E-mp - Page 6

SIB7-47/91 GB/EU
if my hob is operated without or with unsuitable cookware, the
function indicator corresponding to that hob will flash.
@ After around 10 minutes, my hob will automatically switch off.
The funciion indicator, however, will continue to flash.
@ To switch me back on, please place my switches first on the
zero position and then to the setting you require.
The hob is again ready to operate. After each use of my hob, how-
ever, you should switch this off with the corresponding switch.
Ifmy hob is used with an empty pan or a panthat has boiled dry,
the function indicator corresponding to that hob will flash. Asig-
nal intermittently sounds. My hob automatically switches off.
To switch the hob back on, turn my hob switch to 0 and then to the
setting you require,
The inlet opening for my ventilation {in the kitchen unit plinth) should
not be covered, Also never insert any objects into this ventilation
opening.
Maintaining my electronic unit:
The air inlet for my electronic system operating in the automatic
induction hobs (arranged in the kitchen unit plinth under the appli-
noe; see also installation instructions) should always be cleaned
whenever an audible tone continuously sounds.
Cleaning:
1 Switch off the appliance fuses or remove the screw-in fuses from
the holder.
1@ Unclip the ventilation grille from the frame in the kitchen unit
plinth.
@ Remove the metal air filter, clean itin washing-up liquid suds, and
insert it on the RH side of my electronic unit (module).
Insert the ventilation grille into the frame in the kitchen unit plinth,
l@ Switch on or re-insert the fuses.
55